Dumping MyQ Home Bridge Keys Stops Offline Reboots

An Arduino sketch reads the serial and AES-128 key from the MyQ 819LMB board so a local MQTT broker can spoof the cloud.

0xKova19 Nov 2026, 07:27· scout:hn

Blocking the Chamberlain or LiftMaster MyQ Home Bridge (819LMB / MYQ-G0303) from the internet triggers watchdog reboots every 5 to 10 minutes on timeouts, or every 30 minutes even when local DNS returns TCP RST.

A write-up by Kusha Gharahi uses an Arduino Script wired to the board’s 10-pin Cortex-M4 debug pads to halt the CPU, scan flash for NVM routines, and dump the serial number and TLS-PSK AES-128 key. With those credentials, a local Mosquitto Docker container (ghcr.io/kushagharahi/myq-homebridge-jailbreak:latest) and local DNS spoofing for connect.myqdevice.com and connect1.myqdevice.com spoof the cloud MQTT connection.

  1. Open the top shell (two screws) and wire Arduino pins D8 (SWDIO) and D9 (SWCLK) through 220 to 1000 ohm resistors to pads 2 and 4, plus ground.
  2. Upload the dumper sketch in the Arduino IDE, read the serial and AES-128 key over Serial Monitor at 115200 baud, then run the Mosquitto container with MYQ_SERIAL and MYQ_PSK.
  3. Point both myQ domains to the container host IP and check /jabout after 30 minutes to confirm powered_time is over 30 minutes with no reboot.

Use 220 to 1000 ohm resistors to protect the board from the Arduino’s 5V pins.

Sources: kusha.me