rp2350-switch-pad lets friends use their pads on your Switch 2 over Parsec
An open-source Windows app and a cheap RP2350 board stream a Switch 2 to friends and pass their gamepad input back to the console.
A new open-source tool, rp2350-switch-pad, lets you stream your Switch 2 to friends over Parsec, the remote play app, and let them use their gamepads on the console. The project is by komabear and runs on Windows 10 or 11. You need a cheap Waveshare RP2350-USB-C board, a small microcontroller board that acts as a wired PowerA controller on the Switch 2 dock. The author says nothing on the console is modified.
The Windows app reads whatever pad is on your PC, including the virtual Xbox pad Parsec creates for each guest, and passes its input to the board. A built-in capture window shows the Switch screen and sound from an HDMI capture card at 1080p60, ready to share in Parsec, Discord or OBS.
Setup means downloading the release zip, flashing the board’s bridge.uf2 once, and wiring its two USB-C ports to the dock and your PC in the order the README gives. Run the app and wait for the lights to go green. Use two good data cables, since some cables only charge. The author tested with a UGREEN HDMI capture card and a MEUYAG dock, which is an unofficial dock.
Limits: Windows only for now. Each board counts as one controller, so a second player needs a second board. The exe is unsigned, so SmartScreen may warn on first run. The PC link can go idle, and replugging the PC-side USB cable fixes it. The author tested only a Switch 2 dock, not a Switch 1. Input lag adds up across the capture card and Parsec, and lower resolution cuts it further.