ESP USB BLE HID v3.2.0 adds Xbox 360 mode for the Switch dongle
ESP USB BLE HID v3.2.0 adds an Xbox 360 (X-Input) mode and keeps settings across reboots for the Xbox-to-Switch dongle.
A small ESP32-S3 dongle that turns a wireless Xbox controller into a Switch Pro Controller just got version 3.2.0. The project is ESP USB BLE HID, open-source firmware by finger563. The dongle talks to the controller over Bluetooth LE and shows up in the Switch dock as a wired Pro Controller.
The main addition is Xbox 360 (X-Input) as a second USB controller type, chosen from the console. The release notes don’t say which consoles or games accept that mode, so check before you rely on it for a specific setup.
Two fixes matter for daily use. Settings now survive reboots, which needs espp/nvs 1.3.10 or newer. Forgetting a paired controller also works while the dongle is scanning. The firmware grew by 3,480 bytes compared with v3.1.0.
To try it, get a LilyGo T-Dongle-S3 and run the programmer from the latest release once. Then:
- On the Switch, go to System Settings → Controllers and Sensors → Pro Controller Wired Communication and turn it on.
- Plug the dongle into the dock and hold its button for 3 seconds until the LED pulses blue.
- Put your controller in pairing mode.
Later updates install from GitHub through the web console over USB, so you only need the programmer once. Other ESP32-S3 boards need a build from source.
