BC-250 power controller v8 adds a Wi-Fi page and a low-battery warning
Firmware v8 for the Pico 2 W board that gives the AMD BC-250 a real power button adds a Wi-Fi setup page and controller battery warnings.
The AMD BC-250 lacks a proper power button when running SteamOS. The Dkhanas bc250-power-controller project adds one with a small board built around a Raspberry Pi Pico 2 W. The latest commit brings firmware v8, updated documentation and two firmware files: one plain, one with Home Assistant support.
The Pico sits on the PSU’s 5 V standby rail. A short press on the case button turns the PSU on or starts a clean SteamOS shutdown. Holding it for 5 seconds forces the PSU off. Pressing PS, Xbox or Home on a Bluetooth controller wakes the board, and the controller is passed to the BC-250 over USB.
V8 adds an optional Wi-Fi page at http://bc250.local. From there you can power on or shut down, see controller battery levels, and pair or forget controllers. A DualSense or DualShock at 20 % or less makes the controller rumble and the button LED blink.
Firmware v8 compiles cleanly but hasn’t been tested on real hardware yet, though versions 4 and 5 ran on the real board. Wi-Fi and Bluetooth share one radio chip, so controllers may lag if Wi-Fi is set to Always. Wi-Fi is 2.4 GHz only.
To try it:
- Hold BOOTSEL on the Pico, plug it in, and copy bc250_power_v8.uf2 onto the RP2350 drive (or bc250_power_v8_ha.uf2 for Home Assistant).
- On the BC-250, set the AUTO_PWRON jumper on pins 1-2, and set HandlePowerKey=poweroff in SteamOS.
- Wire the board as described in docs/build-plan.md.
