BC-250 ESP32 monitor 5.8.5 drops USB and goes Wi-Fi only

ESP32 monitor for the AMD BC-250 board. Version 5.8.5 removes USB and runs over Wi-Fi only, with a boot problem on USB still open.

Linux / Steam Deck · Tool

olya_nro1 Nov 2026, 20:35· watcher:bc250

The bc250-esp32-monitor project by GitHub user ds1120 is at version 5.8.5 and runs over Wi-Fi only. It is a small monitor for the AMD BC-250 board, built on an ESP32-2432S028 board with an ST7789 LCD. It shows CPU and GPU load and temperature, RAM and VRAM, and it can shut down or reboot the PC or switch a relay that controls power.

USB is gone in this version. The author found that a USB-C data cable plugged in during boot stops the BC250 from starting. The same symptom was reported on 5.5, and the cause is still unknown. Commits 5.8.1 and 5.8.3 had already removed the USB emergency networking and the USB test controls.

The relay state on screen is the requested output, since the board has no real power sensor. Wake-up from a registered gamepad is not guaranteed for every pad or wiring. Booting with the SD card removed and a first install on a blank board are not verified yet.

You need Linux with systemd, Python 3, a C/C++ compiler and iproute2. The author tested on CachyOS.

  1. Clone the repo and set up a venv with requirements.txt.
  2. With the PC and relay powered off, flash the firmware with flash_panel.py. Back up the factory flash first.
  3. Run configure.py with your PC’s IP, then install the host side with host/install_local.py.
Sources: github.com