BC-250 ESP32 monitor 5.8.5 drops USB and runs over Wi-Fi only
The ESP32 monitor and relay for the AMD BC-250 moves to Wi-Fi only in 5.8.5, after a USB boot bug.
The bc250-esp32-monitor project, a DIY monitor and power relay for the AMD BC-250 built on an ESP32, has reached version 5.8.5. Developer ds1120 removed USB from the board workflow entirely, so it runs over Wi-Fi only. The reason is a bug where a USB connection stopped the BC-250 from booting. Version 5.5 showed the same symptom, and the cause remains unconfirmed.
The ESP32 is a Wi-Fi microcontroller board with an ST7789 LCD. Over Wi-Fi it shows CPU and GPU load and temperature, plus RAM and VRAM. Through a relay it shuts the PC down cleanly, reboots it or cuts power. A registered gamepad can wake the PC. Settings from the SD card are also copied into the internal NVS memory, so PC and pad settings survive without the card. The relay state shown is a request, since there is no real power sensor, and pad compatibility is not guaranteed.
You need Linux with systemd, Python 3, a C/C++ compiler and iproute2. The first flash runs with the PC and relay power disconnected:
- Back up the full flash with esptool. Keep that file private, since it holds secrets.
- Flash binaries/bc250-monitor-5.8.5.bin with flash_panel.py.
- Set your Wi-Fi, PC IP and pad with configure.py.
- Install the companion on the PC with install_local.py.
Still unverified: booting with the SD card removed, a fresh blank board, and output stability during brownouts. Wireless updates leave the PC off by default. The keep-power test needs –keep-power-test, so save your work first.
