# tico FCEUmm 3.0.2 stops forcing low clocks on Switch

> The NES emulator module for the tico frontend on Switch, version 3.0.2, no longer sets a fixed clock profile when a game starts.

- Published: 2026-10-23T14:14:50Z
- Score: 8/10
- Tags: switch, emulator, homebrew
- Port / platforms: NES -> Switch (Emulator)
- Web page: https://emu-radar.customfw.xyz/news/tico-fceumm-3-0-2-clock-fix/
- Sources: https://github.com/ticohq/tico-fceumm

The tico fork of [FCEUmm](https://github.com/libretro/libretro-fceumm), a Nintendo Entertainment System and Famicom emulator, is at 3.0.2 for the Switch. The new version stops the emulator from setting a fixed clock profile when a game starts. It needs tico 0.8.0 or later.

tico is the [frontend](https://ticoverse.com) this module plugs into, and it has its own module store.

That profile caused the problem. On the TV, it dropped the GPU and memory below the Switch's normal speeds. If your overclock tool's override was off, every game ran at 460 MHz GPU and 1600 MHz memory. Now games run at the Switch's normal clocks, or at whatever your overclock tool sets.

The 3.0.1 release fixed sound before that. Audio had been playing slightly too slow, so it sounded low and crackled even at full speed. It now plays at the rate the Switch expects.

The notes don't say which games were tested for the clock change.

How to try it:

1. Check that tico is 0.8.0 or later.
2. Update from the tico Store, or extract `tico-fceumm-module.zip` into `sdmc:/tico/modules/`.
3. Your saves, states and settings carry over.

If you run an overclock tool, check its override setting after updating. The override decides which clocks the game uses.
