# GameCube controller can drive the Wii Menu cursor through a Priiloader hack

> A Priiloader hack lets a GameCube pad move the Wii System Menu cursor with no Wii Remote connected. Only menu version 4.3U works.

- Published: 2026-10-19T05:19:42Z
- Score: 7/10
- Tags: wii, gamecube, homebrew
- Port / platforms: Wii -> Wii (Mod)
- Web page: https://emu-radar.customfw.xyz/news/gamecube-controller-wii-menu-cursor-priiloader-hack/
- Sources: https://gbatemp.net/threads/gamecube-controller-cursor-for-the-wii-system-menu.685554/

A new Priiloader hack lets a GameCube controller drive the Wii System Menu pointer when no Wii Remote is connected. It only works on System Menu 4.3U (v513). The author tested it on real hardware and in [Dolphin](https://dolphin-emu.org) with Priiloader 0.9.1.

Priiloader is the boot-time loader that runs patches on the System Menu of softmodded Wiis. The hack comes from Zeldocto, a new member of [GBAtemp](https://gbatemp.net), and the thread has no replies yet. The stick moves the cursor, and the GC buttons act as Wii Remote buttons, HOME included. A switched-on Wii Remote takes priority, so the pad only takes over when no remote is connected. That helps when your remotes are dead or missing, or when you want to boot straight into Nintendont games.

The install is fiddly:

1. Make a BootMii NAND backup first.
2. Write down your enabled hacks in System Menu Hacks.
3. Paste the attached gc_cursor_hack.ini at the end of SD:/apps/priiloader/hacks_hash.ini, keeping each patch= line on one line.
4. Boot Priiloader, enable GameCube Controller Cursor, turn your other hacks back on, and save.

Adding a hack shifts Priiloader's list positions, so existing hacks switch off until you re-enable them. The hack patches the menu in memory only, so uninstalling it through Priiloader leaves the NAND alone apart from Priiloader's own settings. Wii U and vWii are untested.

The menu already contains a GameCube pad library. The author hooks into it where the menu needs it.
