# ESP USB BLE HID v3.2.0 adds Xbox 360 mode for the Switch dongle

> ESP USB BLE HID v3.2.0 adds an Xbox 360 (X-Input) mode and keeps settings across reboots for the Xbox-to-Switch dongle.

- Published: 2026-11-08T05:30:22Z
- Score: 7/10
- Tags: homebrew, tool, switch
- Port / platforms: - -> Switch (Tool)
- Web page: https://emu-radar.customfw.xyz/news/esp-usb-ble-hid-v3-2-0/
- Sources: https://github.com/finger563/esp-usb-ble-hid

A small ESP32-S3 dongle that turns a wireless Xbox controller into a Switch Pro Controller just got version 3.2.0. The project is ESP USB BLE HID, open-source firmware by finger563. The dongle talks to the controller over Bluetooth LE and shows up in the Switch dock as a wired Pro Controller.

The main addition is Xbox 360 (X-Input) as a second USB controller type, chosen from the console. The release notes don't say which consoles or games accept that mode, so check before you rely on it for a specific setup.

Two fixes matter for daily use. Settings now survive reboots, which needs espp/nvs 1.3.10 or newer. Forgetting a paired controller also works while the dongle is scanning. The firmware grew by 3,480 bytes compared with v3.1.0.

To try it, get a LilyGo T-Dongle-S3 and run the programmer from the latest release once. Then:

1. On the Switch, go to System Settings → Controllers and Sensors → Pro Controller Wired Communication and turn it on.
2. Plug the dongle into the dock and hold its button for 3 seconds until the LED pulses blue.
3. Put your controller in pairing mode.

Later updates install from GitHub through the web console over USB, so you only need the programmer once. Other ESP32-S3 boards need a build from source.
